Others

 

Others

ISO 6806:2024 - Rubber hoses and hose assemblies for use in oil burners — Specification
- This document specifies the minimum requirements for rubber hoses and hose assemblies for use in oil burners.The following two types of hose assembly are specified:—    ...
ISO 4641:2024 - Rubber hoses and hose assemblies for water suction and discharge — Specification
- This document specifies the minimum requirements for textile-reinforced, smooth-bore rubber water-suction and discharge hoses and hose assemblies.Three types of hoses and hose assemblies...
ISO 5600:2024 - Rubber — Determination of adhesion to rigid materials using conical shaped parts
- This document specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the...
ISO 10928:2024 - Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use
- This document specifies procedures suitable for the analysis of data which, when converted into logarithms of the values, have either a normal or a skewed distribution. It is intended for use...
ISO/TS 23927:2024 - Laminates and moulding compounds — Prepregs — Determination of tack
- This document specifies the test method for determining the tack in prepregs under defined conditions.This document is applicable to but not limited to unidirectional and...
ISO 8605:2024 - Fibre-reinforced plastics — Sheet moulding compound (SMC) — Requirements and specifications
- This document establishes requirements and specifications for sheet moulding compound (SMC) used in the production of composite parts by hot moulding.It is suitable for sheet moulding...
ISO 4437-5:2024 - Plastics piping systems for the supply of gaseous fuels — Polyethylene (PE) — Part 5: Fitness for purpose of the system
- This document specifies the requirements of fitness for purpose of assembled polyethylene (PE) piping systems in the field of the supply of gaseous fuels.It specifies the requirements...
ISO/TS 22499:2024 - Thermoplastic pipes for the conveyance of fluids — Inspection of polyethylene butt fusion joints using phased array ultrasonic testing
- This document describes the phased array ultrasonic testing (PAUT) of polyethylene butt fusion (BF) joints, including pipe-to-pipe, pipe-to-fitting and fitting-to-fitting joints, used for the...
ISO 4437-1:2024 - Plastics piping systems for the supply of gaseous fuels — Polyethylene (PE) — Part 1: General
- This document specifies materials and the general aspects of polyethylene (PE) piping systems in the field of the supply of gaseous fuels.It also specifies the test parameters for the...