Others

 

Others

Green Synthesis of Fe3O4‐Crataegus tanacetifolia (Lam.) Biochar Magnetic Nanocomposites for Adsorption of Naproxen
15/04/2025 - Biochar was obtained from Crataegus tanacetifolia (Lam.) plant wastes by green synthesis, and magnetic properties were imparted with Fe3O4. Characterization of Ct‐BMNC was performed by XRD,...
Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel
13/04/2025 - A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the...
A Study on Thermal Expansion and Thermomechanical Behavior of Composite Metal Foams
13/04/2025 - The coefficient of thermal expansion of steel–steel composite metal foam (S‐S CMF) is shown to be lower than that of bulk stainless steel while its performance under compression demonstrate...
Study on the Effect of Annealing Temperature on the Forming and Mechanical Properties of Hot‐Pressed Ti/Al/Mg/Al/Ti‐Laminated Composites
06/04/2025 - The research topic of this article is to study the effect of different annealing temperatures on the mechanical properties and formability of hot‐pressed Ti/Al/Mg/Al/Ti laminated composites. It is...
Fabrication and Three‐Point Bending Behavior of Aluminum Foam Sandwich via Controlled Atmosphere Brazing
06/04/2025 - This study employs controlled atmosphere brazing method to fabricate aluminum foam sandwiches with metallurgical bonding interfaces. The filler materials partially wrap around the cell walls,...
Mechanical Properties of 3D‐Printed Polymeric Cellular Structures Based on Bifurcating Triply Periodic Minimal Surfaces
01/04/2025 - The mechanical properties and deformation mechanisms of novel noncubic bifurcating TPMS structures identified through mathematical methods are investigated. The bifurcating TPMS structures show...
Design and Evaluation of 3D‐Printed Polylactic Acid Composites Reinforced with Biodegradable Bamboo Powder and Jute Powder
28/03/2025 - The study investigates 3D‐printed polylactic acid (PLA) composites with biodegradable bamboo and jute powder fillers. Mechanical, thermal, structural properties, and rheological behavior are...
Strain Rate Effect on the Structural Performance of Mathematically Generated Metastructures
28/03/2025 - This study investigates the strain‐rate‐dependent mechanical response of 3D‐printed triply periodic minimal surface (TPMS) structures fabricated from glass micro‐balloon‐reinforced...
Preparation and Mechanical Properties of Diamond Films on Textured WC–Co Substrate
28/03/2025 - Herein, surface texturing effects on diamond film performance are investigated. Four laser‐fabricated textures on WC–Co substrates are coated by hot filament chemical vapor deposition, with...
A Highly Stable Organic–Inorganic Hybrid Electron Transport Layer for Ultraflexible Organic Photodiodes
30/03/2025 - Organic photodiodes (OPDs) with low dark current and stable detectivity under light irradiation, air exposure, and heating are realized using a nanoparticle‐based Zn‐chelated PEIE (PEI‐Zn NP)...
Durable Proton Exchange Membrane Based on Polymers of Intrinsic Microporosity for Fuel Cells
27/03/2025 - A novel composite proton exchange membrane (PEM) design that leverages carboxylic acid‐functionalized polymers of intrinsic microporosity (cPIM‐1) and polyvinylpyrrolidone (PVP). Harnessing Lewis...
Development of microprefilter for chromatography column in HbA1c assays
- The complexity of blood and its matrix in high-performance liquid chromatography (HPLC) glycated hemoglobin (HbA1c) assays is closely related to column performance. However, the available...
Rapid and accurate identification of foodborne bacteria: a combined approach using confocal Raman micro-spectroscopy and explainable machine learning
- This study proposes a rapid identification method for foodborne pathogens by combining Raman spectroscopy with explainable machine learning. Spectral data of nine common foodborne pathogens are...
Mass Finishing of Ti–6Al–4V Additively Manufactured by Laser Metal Deposition with Powder Process
21/03/2025 - This article describes the development of a staged/hybrid mass finishing (MF) approach for the post‐treatment of laser‐metal‐deposited Ti–6Al–4V parts. It aims at enhancing process...
Synergistic Effect of Surface Microstructure and Ag3PO4 on Antimicrobial Performance of Polypropylene‐Based Composites
20/03/2025 - Herein, composites with excellent antibacterial properties are prepared by introducing Ag3PO4 into the polypropylene matrix and regulating surface microstructure. The findings indicate that...
Ultrafast Superradiant Scintillation from Isolated Weakly Confined Perovskite Nanocrystals
21/03/2025 - Efficiency and scintillation velocity are critical for high‐energy and medical physics. These parameters, typically conflicting in conventional scintillators, are simultaneously optimized by...
Phytochemical Investigation, Antibacterial and Antioxidant Activity Determination of Leaf Extracts of Cynoglossum coeruleum (Shimgigit)
- The leaf of Cynoglossum coeruleum is traditionally used in tropical medicine for treating various ailments. This study analyzed the phytochemicals, flavonoid and phenolic content,...
The Zero Violence Brave Club: a successful educational action to overcome isolating gender-based violence with young adolescents
25/03/2025 - This paper provides a robust test of predictability under the predictive regression model with possible heavy-tailed innovations assumption, in which the predictive variable is persistent and its...
Zulassungserweiterung für RSV-Impfstoff
21/03/2025 - The impacts of IT system application on firm performance have been extensively examined in the existing literature, yielding mixed conclusions. This study aims to investigate the effects of...
Core/Shell‐Structured Carbon Support Boosting Fuel Cell Durability
16/03/2025 - The study designs a bifunctional core/shell‐structured carbon support with the core of highly graphitized carbon and the shell of heteroatom‐doped amorphous carbon, precise control of Pt...
Sperm DNA methylation landscape and its links to male fertility in a non-model teleost using EM-seq
18/03/2025 - Objectives Earlier investigations have documented an association between elevated consumption of Ultra-Processed Foods (UPFs) and adverse renal outcomes. To explore this...