Others

 

Others

ISO 4641:2024 - Rubber hoses and hose assemblies for water suction and discharge — Specification
- This document specifies the minimum requirements for textile-reinforced, smooth-bore rubber water-suction and discharge hoses and hose assemblies.Three types of hoses and hose assemblies...
ISO 5600:2024 - Rubber — Determination of adhesion to rigid materials using conical shaped parts
- This document specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the...
ISO 17717:2024 - Meteorological balloons — Specification
- This document specifies the minimum requirements and the test methods for meteorological balloons made from natural rubber latex or natural rubber latex compounded with synthetic rubber...
ISO 5603:2024 - Rubber, vulcanized — Determination of adhesion to wire cord
- This document specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber.The two methods do not necessarily give the...
ISO 7965-1:2024 - Packaging — Drop test — Part 1: Paper sacks
- This document specifies a method of vertical impact testing on a filled paper sack by dropping. It is performed either as a single test to investigate the effects of vertical impact or as part...
ISO/ASTM 52927:2024 - Additive manufacturing — General principles — Main characteristics and corresponding test methods
- This document specifies the principal requirements applied to the testing of parts produced by additive manufacturing processes.This document—     identifies quality...
ISO 4628-10:2024 - Paints and varnishes — Evaluation of quantity and size of defects, and of intensity of uniform changes in appearance — Part 10: Assessment of degree of filiform corrosion
- This document specifies a method for assessing the amount of filiform corrosion developed from a scribed mark by measuring the length of the longest filament L and the most frequent...
ISO 10928:2024 - Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use
- This document specifies procedures suitable for the analysis of data which, when converted into logarithms of the values, have either a normal or a skewed distribution. It is intended for use...
ISO/TS 23927:2024 - Laminates and moulding compounds — Prepregs — Determination of tack
- This document specifies the test method for determining the tack in prepregs under defined conditions.This document is applicable to but not limited to unidirectional and...
ISO 3384-1:2024 - Rubber, vulcanized or thermoplastic — Determination of stress relaxation in compression — Part 1: Testing at constant temperature
- This document specifies two procedures for determining the decrease in counterforce exerted by a test piece of vulcanized or thermoplastic rubber which has been compressed to a constant...